Rectangular Adhesive Vent for Boat and Industrial Shrink Wrap

Allow excess heat and moisture to escape your completed shrink wrap enclosure by installing rectangular adhesive vents!

These easy to install vents are applied over a small square-shaped cut in the completed shrink wrap. Protective backing is peeled away from adhesive strips on the flat back of the vent. Then, the flat back of the vent is pressed onto the shrinkwrap covering the square-shaped cut. The only tool you need is a safety blade or scissors.

Providing better air flow routes in and out of your shrink wrap enclosure will reduce temperature differentials which will reduce the likelihood that condensation, mold, and mildew will develop.

The adhesive which secures these vents can remain effective for years (depending on environmental conditions).

Be sure to look at Mr. Shrinkwrap's Shrink Wrap Installation Supplies page for Crosswoven Strap, Zipper Doors, or other items you might need for your project. If you don’t have a heat tool, you can pick one out for yourself here, or you can Rent a Heat Tool from Mr. Shrinkwrap.

Mr. Shrinkwrap is a leading distributor of protective products, shrink wrap films and installation supplies with a dedicated team available to take your order at any time of day. We have several experienced shrink wrap installation technicians on staff to help and support you on various aspects of any shrink wrap project. If you would like to place an order over the phone or have questions for us, give Mr. Shrinkwrap a call at 800-847-5290.