Shrink Wrap Installation Supplies - Products Below
From end caps to zipper doors, Mr. Shrinkwrap has you covered with a complete selection of installation supplies for any shrink wrap tools.
Vents - are useful on nearly anything that is in need of air flow; to help air move both in and out from under your cover at least two openings are reccomended, put a couple of vents up high and a couple down low if there are no air passages at the base of the cover.
Moisture Control Desiccant Bags - Useful in enclosed spaces to keep condensation from forming, our dessicant bags are rated for three (3) cubic feet and have been tested to absorb moisture for as long as six months. Great for keeping condensation out of shipping containers as well as in a boat where it can lead to mildew and damage to surfaces.
End Caps & Bottom Caps - Designed to fit the cut end of a two by four, end caps hold the shrink wrap up off of the support braces and create a smooth flat surface for the shrink film to reach across at the desired height while also providing a smooth but substantial base for the support brace when under tension of stapping.
Strapping - Strapping is essential to shrink wrapping by providing an anchor point for the edge of the shrink wrap where needed. The strapping can be drawn tight by using the strap tensioning ratchet tool and buckles.
Zipper Doors & Hatches - Useful for inspection hatches, full or limited access doors are a great solution for lifting points, tie-down rings or any other quick access through a shrink wrap installation.
Mr. ShrinkWrap is a leading distributor of shrink wrapping supplies and installation tools with a dedicated team available to take your order at any time of day. We also have several experienced shrink wrapping technicians on staff to help and support you on various aspects of any shrink wrap project. If you have a question, give us a call at 800-847-5290.